|
| |
Malfunction
Test or Inspection
Corrective Action
TM 9-2320-304-14&P
4-26
Organizational Maintenance Instructions (Cont)
4-18. TROUBLESHOOTING INSTRUCTIONS (CONT).
Table 4-3. Load Handling System (LHS) Troubleshooting (CONT)
LOAD HANDLING SYSTEM (LHS) (CONT)
2. LHS NO TRANSIT INDICATOR DOES NOT OPERATE (CONT).
WARNING
·
Keep clear of equipment when equipment is being raised or lowered. Equipment
may fall and cause serious injury or death to personnel.
·
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact
positive electrical circuits, a direct short may result. Damage to equipment and
injury or death to personnel may occur.
Step 2. Check for 22 to 28 Vdc on wire 1725 at LHS NO TRANSIT indicator connector with
ENGINE switch in ON position and LHS raised.
If there are 22 to 28 Vdc at indicator connector, go to Step 11. of this Fault.
If Vdc measurement is below specification, go to Step 3. of this Fault.
|
