|
| |
TM 9-2320-304-14&P
3-1
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
3 3
Contents
Para
Page
Maintaining Lubricant Levels
3-1
3-1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
General Lubrication Instructions
3-2
3-1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Troubleshooting Introduction
3-2.1
3-4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Troubleshooting Procedures
3-3
3-4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Maintenance Introduction
3-4
3-8.4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Clean Vehicle
3-5
3-8.4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Section I. Lubrication Instructions
3-1. MAINTAINING LUBRICANT LEVELS.
Lubricant levels must be checked as specified in the PMCS (Chapter 2, Section II) and Lubrication Table. Steps
must be taken to replenish and maintain lubricant levels.
3-2. GENERAL LUBRICATION INSTRUCTIONS.
WARNING
·
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles,
face shield, and gloves; use only in a well-ventilated area; avoid contact with skin,
eyes, and clothes; and do not breathe vapors. Keep away from heat or flame. Never
smoke when using solvent. The flashpoint for Type III Drycleaning Solvent is 200_F
(93_C). Failure to do so may result in injury or death to personnel.
·
If personnel become dizzy while using cleaning solvent, immediately get fresh air
and medical help. If solvent contacts skin or clothes, flush with cold water. If solvent
contacts eyes, immediately flush eyes with water and get immediate medical
attention.
a. Cleaning Fittings Before Lubrication. Clean parts with Drycleaning Solvent P-D-680 (Item 18,
Appendix F) or equivalent. Dry before lubricating. Dotted arrow points indicate lubrication on both
sides of the equipment.
b. Lubrication After Fording. If fording operation occurs, lubricate all fittings below fording depth.
c. Lubrication After High-Pressure Washing. After a thorough washing, lubricate all grease fittings
and oil can points outside and underneath vehicle.
d. Localized Views. A reference to the appropriate localized view is given after most lubrication
entries. Localized views begin on page 3-3.
Change 1
|
