|
| |
TM 9-2320-304-14&P
Operating Instructions (Cont)
(9) Move joystick (8) to LOAD until LHS is fully stowed and LHS NO TRANS lamp (9) goes out.
(10) Release joystick (8).
CAUTION
Engine speed must be at idle before using hydraulic selector switch, or damage to
equipment may result.
(11) Turn hydraulic selector switch (7) to OFF.
(12) Put PTO ENGAGE switch (5) in OFF position. Make sure indicator light (6) goes off.
NOTE
There are two slide arms. Right side shown.
(13) Remove lock pin (11), pin (12), and slide arm upper front hook (13) from slide arm (14).
NOTE
Slide arm upper front hooks should face toward rear of truck.
(14) Rotate slide arm upper front hook (13) 180 degrees and install in slide arm (14) with pin (12)
and lock pin (11).
Change 1
2-86.3/(2-86.4 blank)
|
