|
| |
TM 9-2320-304-14&P
LOADING Container 82 in. (208 cm) or
higher (Para 2-10.2), 72 in. (183 cm)
(Para 2-10.3), 51 in. (130 cm) (Para 2-10.4),
48 in. (122 cm) (Para 2-10.5). (CHECKS:
Lower Locks unlocked, FLA configured for
size container, bumper supports rearward,
slider and transit locks ready.)
(1)
Verify that FLA is not locked to HA
and truck is in container mode.
(2)
Back up to container to within 9-ft.
(3 m) align truck with container.
(3)
Cycle LHS to unload until FLA upper
hooks are visible just below top edge
of container.
(4)
Make sure FLA configured for
container, slide arms pinned if needed,
lower container locks unlocked, and
correct hook in slide arm.
(5)
Back truck up until FLA contacts
container. Alining hooks with
container corner openings.
(6)
Cycle LHS to load until hooks are
above container.
(7)
Continue backing up truck until hooks
are positioned over container.
(8)
Cycle LHS to unload to engage hooks
into container top corners.
(9)
Continue to cycle LHS until lower
locks are low enough to engage
container bottom corners.
(10)
Back up truck to engage FLA lower
locks in container corners. Steer truck
to align lower locks with container.
(11)
CHECK: Upper hook thumb engaged,
lower locks flush, sliders positioned
straight ahead, and clean of debris.
(12)
Lock lower locks to container; handle
straight up, lock plate over handle
and handnut.
(13)
Lock other side.
(14)
Cycle LHS to LOAD to lift container
onto truck.
(15)
Observe clearance between container
and slider guides on both sides to
make sure container is centered
during loading.
(16)
Fully load container until LHS
NOT TRANSIT light goes out.
(17)
Pin transit locks in locked
position, RH and LH.
(18)
Verify container is properly loaded
onto the truck.
UNLOADING Container 82 in. (208 cm)
or higher (Para 2-10.2), 72 in. (183 cm)
(Para 2-10.3), 51 in. (130 cm)
(Para 2-10.4), 48 in. (122 cm)
(Para 2-10.5).
(1)
Verify sufficient room and ground
conditions.
(2)
Disengage transit locks, RH and
LH and lock transit locks in ready
position.
(3)
Cycle LHS to UNLOAD container.
(4)
Unlock lower container locks;
handle inward, handnut tightened
up, lock plate over handnut.
(5)
Unlock other side.
(6)
Drive forward approximately 6 in.
(15 cm), to disengage lower locks.
(7)
Cycle LHS to load to disengage
upper hooks from container.
(8)
Continue to cycle LHS fully to
LOAD until LHS NO TRANSIT
light goes out and CHU is in ready
mode.
FOLD
FOLD
Change 1
2-82.159/(2-82.160 blank)
|
