|
| |
TM 9-2320-304-14&P
2-82.140
Operating Instructions (Cont)
2-10.9 LOADING/UNLOADING ISO CONTAINER WITH M3 CROP (CONT).
NOTE
The bracing mechanisms consist of a free-to-rotate cam positioned between two collars
welded to threaded rod. The front adjustment collar is equipped with holes, which a pin can
be inserted to provide leverage to turn and adjust the cam position fore and aft, enabling it
to engage the shoring slot. The same pin is used to secure cam after engaged in shoring
slot.
(18)
Rotate cams (9) in left and right bracing
mechanisms until shoring slots (10) on
both sides of ISO container are engaged.
(19)
If cam (9) will not engage shoring
slot (10), insert pin (11) into adjustment
collar (12) and turn, adjusting cam (9)
forward or aft until cam (9) will engage
shoring slot (10).
NOTE
Depending upon CROP distance from
shoring slots, cams will engage in one of
two positions depicted below as Nominal
Position and Minimum Position. If
required, use a forklift to position CROP so
either Nominal or Minimum position can
be achieved.
Change 1
|
