|
| |
TM 9-2320-304-14&P
2-82.134
Operating Instructions (Cont)
2-10.8 STACKING/LOADING M3 CROP ON TRAILER.
a. Loading and Unloading.
NOTE
·
Refer to TM 9-3990-260-14&P for CROP Stack/Unstacking procedures.
·
Refer to Para 2-9 for Load Handling System (LHS) operation to load/unload CROPs
onto truck.
·
Once CROPs are loaded on truck, they are loaded onto trailer using the following
procedures.
·
The M3/M3A1 CROP should be loaded as close to the center of gravity point as
possible. As the payload reached the maximum lifting capacity of the HEMTT LHS;
if a load is not centered on the CROP the center of gravity can restrict the lifting
capability of the truck. Approximate center of gravity is 111 in. (centered) from the
front edge of the CROP
(1)
Remove CROP loading ramps from their storage location on trailer.
CAUTION
There are left and right side CROP loading ramps. For proper operation, ramps must be
engaged on correct side of trailer. Failure to comply may result in equipment damage
NOTE
·
There are two CROP loading ramps,
right and left side. Right side CROP
loading ramp shown.
·
For proper engagement and
operation of CROP loading ramps,
the following installation
instructions must be followed.
(2)
Position CROP loading ramps with sloped
portion (1) facing forward on trailer frame
bed, toward trailer tongue.
Change 1
|
