|
| |
TM 9-2320-304-14&P
2-82.126
Operating Instructions (Cont)
2-10.7 LIFT CONTAINER OUT OF MUD (CONT).
(3)
Push in parking brake knob (1), apply service brake pedal (2), and set transmission range
selector (3) to R (Reverse).
(4)
Release service brake pedal (2) and position rear of truck within 9-ft. (2.74m) of front of
container (4), alining centerline of truck within 2 in. (5 cm) of container centerline.
(5)
Apply service brake pedal (2) and set transmission range selector (3) to N (Neutral).
CAUTION
Engine speed must be at idle before using hydraulic selector switch, or damage to
equipment may result.
(6)
Put PTO ENGAGE switch (5) in ON position. Make sure indicator light (6) comes on.
(7)
Turn hydraulic selector switch (7) to AUTO.
CAUTION
On steep downgrades, contact is possible between the front lift adapter lower legs and the
rear sliders during empty LHS cycles. If contact appears likely, switch hydraulic selector to
MAN H.A. position and retract (LOAD) hook arm a few inches. Return hydraulic selector to
AUTO and continue (UNLOAD) operation. Repeat as required. Failure to comply may
result in damage to equipment.
(8)
Move joystick (8) to UNLOAD. Hook arm will raise and begin to move rearward. LHS NO
TRANS lamp (9) will illuminate to indicate hook arm is up and load lock has been cleared.
Change 1
|
