|
| |
TM 9-2320-304-14&P
2-82.75
Operating Instructions (Cont)
(25)
Position half-height container front hooks (13) just above and in front of half-height container
upper front corner castings (22).
(26)
Apply service brake pedal (4) and set transmission range selector (5) to R (Reverse).
WARNING
Do not allow front lift adapter to contact the ground when half-height container front hooks
are not engaged with container upper corner castings. Failure to comply may result in
damage to equipment and injury or death to personnel.
(27)
Release service brake pedal (4) and slowly back up to approximately 12 in. (30 cm) from front of
container (6).
NOTE
LHS will only operate when transmission range selector is in N (Neutral).
(28)
Apply service brake pedal (4), set transmission range selector (5) to N (Neutral), move joystick
(10) to LOAD, and raise front lift adapter until half-height container front hooks (13) are above
container upper front corner castings (22).
CAUTION
Make sure half-height container front hooks are fully engaged with container upper corner
castings. Failure to comply may result in damage to equipment.
NOTE
·
To get half-height container front hooks to properly seat it may be necessary to drive
truck forward slightly.
·
When container is on side slope, it may be difficult to get both upper hooks properly
seated. Front lift adapter hangs level. To get front lift adapter to hang closer to
same angle as container, it may be necessary to temporarily remove one rear
container lock from slider and stow on downhill side of front lift adapter.
(29)
Release service brake pedal (4) and move joystick (10) to UNLOAD, lower half-height container
front hooks (13) into half-height container upper front corner castings (22).
(30)
Set transmission range selector (5) to R (Reverse), move truck backward approximately 12 in.
(30 cm).
Change 1
|
