|
| |
TM 9-2320-304-14&P
2-82.63
Operating Instructions (Cont)
CAUTION
Make sure that the slide arm 6-ft. hooks are completely disengaged and do not hang up in
container upper corner castings when retracting LHS. Failure to comply may result in
damage to the slide arm 6-ft. hooks and/or container.
NOTE
·
It may be necessary to move the truck forward or backward slightly to get the slide
arm 6-ft. hooks to disengage.
·
LHS will only operate when transmission range selector is in N (Neutral).
(24)
Move joystick (10) to LOAD position until front lift adapter (20) is disengaged from
container (11).
(25)
Release joystick (10).
(26)
Move truck forward until rear of truck is approximately 9 ft. (2.74 m) in front of container (11).
(27)
Move joystick (10) to UNLOAD position until front lift adapter (20) is positioned approximately
12 in. (30 cm) off the ground.
(28)
Apply service brake pedal (5), set transmission range selector (6) to N (Neutral), and pull out
parking brake knob (13) to apply parking brakes.
CAUTION
·
On steep downgrades, contact is possible between the front lift adapter lower legs
and the rear sliders during empty LHS cycles. If contact appears likely, switch
hydraulic selector to MAN H.A. position and retract (LOAD) hook arm a few inches.
Switch hydraulic selector to MAN M.F. position and retract the main frame until
the front lift adapter clears the rear sliders. Return hydraulic selector to AUTO and
continue (LOAD) operation. Failure to comply may result in damage to equipment.
·
Never drive with LHS NO TRANS lamp illuminated. An illuminated lamp means
that the LHS is not fully stowed. Failure to comply may result in damage to
equipment.
Change 1
|
