|
| |
TM 9-2320-304-14&P
2-82.47
Operating Instructions (Cont)
(26)
Start engine (TM 9-2320-279-10).
(27)
Position slide arm 6-ft. hooks (17) just above and in front of container upper corner
castings (24).
(28)
Apply service brake pedal (4) and set transmission range selector (5) to R (Reverse).
WARNING
Do not allow front lift adapter to contact the ground when slide arm 6-ft. (5.5 m) hooks are
not engaged with container upper corner castings. Failure to comply may result in damage
to equipment and injury or death to personnel.
(29)
Release service brake pedal (4) and slowly back up to approximately 12 in. (30 cm) from front of
container (6).
NOTE
LHS will only operate when transmission range selector is in N (Neutral).
(30)
Apply service brake pedal (4), set transmission range selector (5) to N (Neutral), move
joystick (10) to LOAD and raise front lift adapter until slide arm 6-ft. (5.5 m) hooks (17) are
above container upper corner castings (24).
CAUTION
Make sure slide arm 6-ft. hooks are fully engaged with container upper corner castings.
Failure to comply may result in damage to equipment.
NOTE
·
To get slide arm 6-ft. hooks to properly seat it may be necessary to drive truck
forward slightly.
·
When container is on side slope, it may be difficult to get both upper hooks properly
seated. front lift adapter hangs level. To get front lift adapter to hang closer to
same angle as container, it may be necessary to temporarily remove one rear
container lock from slider and stow on downhill side of front lift adapter.
(31)
Release service brake pedal (4) and, moving joystick (10) to UNLOAD, lower slide arm 6-ft.
hooks (17) into container upper corner castings (24).
(32)
Apply service brake pedal (4) and set transmission range selector (5) to R (Reverse).
Change 1
|
