|
| |
TM 9-2320-304-14&P
2-82.32
Operating Instructions (Cont)
2-10.2 LOADING AND UNLOADING CONTAINER (82 INCHES [208 CM] OR TALLER)
TO TRUCK USING FRONT LIFT ADAPTER (FLA) (CONT).
(5)
Start engine (TM 9-2320-279-10).
(6)
Apply service brake pedal (5) and set transmission range selector (6) to N (Neutral).
(7)
Put PTO ENGAGE switch (7) in ON position. Make sure indicator light (8) comes on.
CAUTION
Engine speed must be at idle before using hydraulic selector switch, or damage to
equipment may result.
(8)
Turn hydraulic selector switch (9) to AUTO.
WARNING
When loading or unloading containers on uneven ground (side slope up to 5 degrees and
downgrades up to 20 percent), it may be necessary to apply truck service brakes to prevent
truck rollaway or severe injury or death could result.
NOTE
LHS will not operate and unload if rear container locks are engaged.
(9)
Move joystick (10) to UNLOAD. Container (11) will start to move rearward. LHS NO TRANS
lamp (12) will illuminate. Maintain engine speed at idle until front of container raises
approximately 12 in. (30 cm).
Change 1
|
