|
| |
TM 9-2320-304-14&P
2-82.17
Operating Instructions (Cont)
(6)
Apply service brake pedal (4) and set transmission range selector (5) to N (Neutral).
(7)
Put PTO ENGAGE switch (7) in ON position. Make sure indicator light (8) comes on.
CAUTION
Engine speed must be at idle before using hydraulic selector switch, or damage to
equipment may result.
(8)
Turn hydraulic selector switch (9) to AUTO.
CAUTION
On steep downgrades, contact is possible between the front lift adapter lower legs and the
rear sliders during empty LHS cycles. If contact appears likely, switch hydraulic selector to
MAN H.A. position and retract (LOAD) hook arm a few inches. Return hydraulic selector to
AUTO and continue (UNLOAD) operation. Repeat as required. Failure to comply may
result in damage to equipment.
(9)
Move joystick (10) to UNLOAD position until front lift adapter (1) is positioned in front of
container (6).
Change 1
|
