|
| |
TM 9-2320-304-14&P
2-75
Operating Instructions (Cont)
CAUTION
Engine speed must be at idle before using hydraulic selector switch or damage to equipment
may result.
(12) Turn the hydraulic selector switch (5) to OFF or MAN TRANS position as required.
(13) Pull out PARKING BRAKE control (10).
(14) Put PTO ENGAGE switch (3) in OFF position. Make sure indicator light (4) goes off.
NOTE
If load locks do not engage raise flatrack slightly and lower again. Flatrack should seat
fully and engage load locks.
(15) Inspect that load locks (11) are engaged and flatrack is fully seated on truck.
|
