|
| |
TM 9-2320-304-14&P
H-2
H-2. LHS BUSHING REMOVER/INSTALLER (SMALL).
Fabricate large LHS bushing remover/installer from 4 in. (101 mm) x 3.339 in. diameter steel stock.
a. Turn round stock to 3.339 in. ±.005 in.
b. Cut a 1/4 in. (6 mm) x 45 degree chamfer where indicated.
c. Drill through a 1.275 in. hole in the center of the 3.339 in. diameter steel stock where indicated.
d. Starting at the end opposite of the chamfer, turn a length of 2.75 in. down to 3.146 in. ±.005 in. where
indicated.
e. Paint as required.
|
