|
| |
TM 9-2320-304-14&P
5-275
Direct Support and General Support Maintenance (Cont)
NOTE
·
LHS should not move when joystick is in UNLOAD position.
·
If LHS does not move in UNLOAD position, go to step (50).
·
If LHS moves in UNLOAD position, perform steps (44) through (48).
(43) Move joystick (25) to UNLOAD position and check LHS for movement (Para 2-9).
(44) Position container lock (23) in locked position and install pin (22) and lock pin (21).
(45) Remove two screws (26) from lock limit switch (27).
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire
and use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
(46) Apply sealing compound to threads of two screws (26).
(47) Position lock limit switch (27) with two screws (26) on slider (20).
NOTE
Lock limit switch is properly adjusted when lever is depressed and lock limit switch makes
an audible click.
(48) Position lock limit switch (27) against container lock (23) until audible click is heard, then
tighten two screws (26).
(49) Repeat step (43) to check LHS for movement.
Change 1
|
