|
| |
TM 9-2320-304-14&P
5-268
Direct Support and General Support Maintenance (Cont)
5-43. CONTAINER HANDLING UNIT (CHU) KIT INSTALLATION (CONT).
(222) Install ISO corner lock (228) on stowage tray (44) and rotate lock handle (229) 90 degrees.
(223) Tighten handnut (230), rotate tab (231) to lock handnut, and install lock pin (232) in
bracket (233).
(224) Repeat steps (221) through (223) for left side.
b. Adjustment.
(1) Deploy both slider assemblies by extending short and long struts (Para 2-9).
(2) Soldier A and Soldier B measure distance between centers of slider pivot pins (1).
NOTE
Adjustment of struts is performed in steps (3) through (13). If distance measured is 88.62 to
89.00 in. (225.09 to 226.06 cm), no adjustment is required.
(3) Adjust long struts (2) so distance measured is 88.62 to 89.00 in. (225.09 to 226.06 cm) between
slider pivot pin (1) centers.
Change 1
|
