 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-2
EQUALIZING BEAM REPLACEMENT - CONTINUED
0287 00
INSTALLATION
WARNING
Make sure all air lines and fittings are clear of debris. Failure to do so could result in equipment failure and/
or injury to personnel.
1.
Install four intermediate tubes (21) in two equalizing beams (17).
2.
Position one equalizing beam (17) on blocks under vehicle and install crosstube (16).
3.
Install second equalizing beam (17) on crosstube (16) and blocks under vehicle.
NOTE
Rotate adapters so flat side is vertical. Do not tighten adapters until both ends are installed.
4.
Using block of wood and jack stand, raise rear ends of two equalizing beams (17). Install four new adapters (13), two
washers (14), two screws (15), two washers (18), and two nuts (19) hand-tight.
5.
Repeat step 4 for front end of two equalizing beams (17) in forward-rear axle (2).
6.
Tighten four nuts (19) to 210-240 lb-ft (285-325 Nm).
7.
Install four saddle caps (20), eight washers (23), and eight nuts (22) on two spring assemblies (3). Tighten nuts to 225-
275 lb-ft (305-373 Nm).
3
16
13
14
15
15
14
17
21
19
21
13
13
18
23
22
19
13
18
20
0287 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals