 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-2
EQUALIZING BEAM REPLACEMENT - CONTINUED
0287 00
REMOVAL - CONTINUED
NOTE
Steps 3 through 5 are for rear axle.
3.
Remove four air hoses (11) from rear brake chambers (10).
NOTE
Spider assembly consists of air brake chamber, S-cam, and slack adjuster.
4.
Remove 16 nuts (6), 16 washers (7), 16 screws (8), 16 washers (9), and two spider assemblies (12) from both sides of
rear axle (5).
5.
Using suitable floor jack, support rear axle (5).
6.
Repeat steps 3 through 5 for forward-rear axle (2).
6,7,8,9
10
11
2,5
12
7.
Remove eight nuts (22), eight washers (23), and four saddle caps (20) from two spring assemblies (3).
8.
Using block of wood and jack stand, support rear ends of two equalizing beams (17). Remove two nuts (19), two wash-
ers (18), two screws (15), two washers (14), and four adapters (13) from rear end of two equalizing beams. Discard
adapters.
9.
Lower rear ends of two equalizing beams (17) onto blocks.
10.
Repeat steps 8 and 9 for front end of two equalizing beams (17).
11.
Remove four intermediate tubes (21) from two equalizing beams (17).
0287 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals