 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-2
STEERING COLUMN REPLACEMENT - CONTINUED
0266 00
REMOVAL - CONTINUED
NOTE
Heat base of yoke, if necessary, for ease in removal.
5.
Remove nut (4) and bolt (5) from steering column yoke (6) and separate yoke from steering column (3). Discard nut and
bolt.
6.
Remove two screws (9) and spacer block (10) from steering column (3) and steering column bracket (7).
7.
Loosen two screws (8) and remove steering column (3) from vehicle.
INSTALLATION
1.
Position steering column (3) to steering column bracket (7) and tighten two screws (9) to 15 lb-ft (20 Nm).
2.
Install spacer block (10) with two screws (9).
3.
Using wire brush and liquid detergent, clean serrations of steering column yoke (6) and shaft.
4.
Apply adhesive primer to steering column shaft. Let dry for five minutes.
5.
Apply sealing compound to inside of steering column yoke (6) and install yoke to shaft.
6.
Install bolt (5) and nut (4). Tighten nut to 37 lb-ft (50 Nm).
7.
Apply sealing compound to exposed threads of screw.
8.
Connect horn wire to steering column (3).
9.
Connect connector to turn signal switch (1).
10.
Install turn signal switch (1) to steering column (3) and tighten clamp screw.
11.
Install trailer brake control valve (2) and tighten clamp.
12.
Install steering wheel (WP 0156 00).
13.
Test drive to check steering wheel alignment and smooth operation of steering column.
END OF WORK PACKAGE
0266 00-3/4 blank
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals