Click here to make tpub.com your Home Page

Page Title: DISASSEMBLY - CONTINUED
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2320-303-24-2
AIR DRYER REPAIR - CONTINUED
0262 00
DISASSEMBLY - CONTINUED
NOTE
Perform step 23 to remove PRESSURE RELIEF VALVE.
23.
Remove pressure relief valve (43) from air dryer (3).
43
3
INSPECTION
Inspect valve bores in air dryer for wear and damage. If wear or damage is found that would prevent a tight seal with
valve components, replace air dryer.
ASSEMBLY
NOTE
Lubricate all O-rings and seals with grease included in parts kit prior to installing.
Perform step 1 to install PRESSURE RELIEF VALVE.
Pipe threads of new pressure relief valve are already coated with sealant. Additional sealant is not
required.
1.
Install pressure relief valve (43) to air dryer (3). Tighten pressure relief valve to no greater than 30 lb-ft (41 Nm).
NOTE
Perform steps 2 through 7 to install HEATER ASSEMBLY.
2.
Connect heater wire (37) and wire (42) to thermostat (38).
3.
Position heater element (39) and thermostat (38) into air dryer (3).
4.
Install thermostat retainer (40) to air dryer (3) with screw (41).
5.
Install new O-ring (35) to connector (34).
6.
Connect heater wire (36) and wire (42) to connector (34).
7.
Push connector (34) into air dryer (3) and install two screws (33).
0262 00-6

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business