 |
|||
|
|
|||
|
Page Title:
Assemble the Gear Cover onto Carrier |
|
||
| ||||||||||
|
|
 TM 9-2320-303-24-2
FORWARD-REAR AXLE DIFFERENTIAL CARRIER REPAIR - CONTINUED
0257 00
DIFFERENTIAL CARRIER ASSEMBLY - CONTINUED
(4)
Slide the yoke (15) over the installation shaft, alining yoke and shaft splines of drive unit.
(5)
Place installation collar over the installation shaft, against yoke (15).
(6)
Thread nut onto installation shaft, against the collar. Continue threading the nut against collar until yoke
(15) seats against bearing. A torque value of 200 lb-ft (270 Nm) on nut may be required to properly install
and seat yoke.
CAUTION
Do not use a prevailing torque nut to install the yoke, as damage to the threads will result. Use only the nut
furnished with tool.
(7)
Remove all parts of the installation tool from the drive unit.
(8)
Install washer and nut (16). Tighten nut to 450-600 lb-ft (610-813 Nm).
16
15
17
19
402-695
Assemble the Gear Cover onto Carrier.
n.
(1)
Before assembling the cover (17) to differential carrier (19), coat the forward interaxle differential side
gear thrust washer (57) and back face of integral shift collar gear (on input shaft) (33) with grease (Item
23, WP 0312 00).
(2)
Place the thrust washer (57) onto the back face of shift collar gear (33). The grease will allow the washer to
stick to the gear.
33
57
402-981
0257 00-45
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals