Assemble the Main Differential and Ring Gear Assembly cont'd

TM 9-2320-303-24-2

FORWARD-REAR AXLE DIFFERENTIAL CARRIER REPAIR - CONTINUED

0257 00

DIFFERENTIAL CARRIER ASSEMBLY - CONTINUED

(i) Place the other clutch holdout-ring (87) assembly on the spider (88) again, indexing the teeth, and

being sure again that the spider-key and holdout-ring slot are properly aligned. Assemble the spring

(85) over the clutch with larger diameter of spring against the clutch.

(j) Place the other spring (84) retainer over the other side gear splines (cup section up with the retainer

firmly seated against the side gear flange), and assemble the spring retainer and side gear over the

spring.

(k) Mount the mating half of the case (76) over the side gear (83) and compress unit. Be sure the side gear

splines are completely indexed with the clutch splines.

86,87

402-664

(l) Hold the case (76) halves together firmly, alining the punch marks to be sure the two case halves are

properly mated. Start threading some of the case bolts but do not release hand pressure until two or

more bolts are drawn up enough to overcome the spring pressure.

IDENTIFICATION MARKS

CASE BOLTS

CASE HALVES

402-674

(m) Tighten case bolts to a torque of 85-115 lb-ft (115-156 Nm). Check to be certain of a snug fit between

the two case halves at all points and between the holes in case and the spider trunnions.

(4)

If roller bearings and bearing cones have been removed, press cone onto each end of assembly using a suit-

able sleeve.

0257 00-29