|
|
TM 9-2320-303-24-2
REAR AXLE REPLACEMENT - CONTINUED
0255 00
INSTALLATION
WARNING
Axle housing is heavy and can injure personnel if dropped. Support axle housing during installation.
NOTE
Procedure is the same for all rear axles except where noted.
If axle housing was replaced, install differential carrier assembly in accordance with WP 0256 00 for
forward-rear axle or WP 0258 00 for rear-rear axle.
1.
Align axle housing (7) with equalizing beam end (21) and install two bushings (20), washer (16), screw (17), washer
(18), and new locknut (19). Tighten screw to 210-240 lb-ft. (285-325 Nm).
21
7
20
16,17,
16,17,
18,19
18,19
20
2.
Repeat step 1 for opposite side.
NOTE
If reinstalling axle, perform step 3. If installing new axle, perform step 4.
3.
Install torque rod (9), any spacer(s) (12), two washers (10), two screws (11), two washers (14), and two new locknuts
(13). Tighten locknuts to 120-152 lb-ft (163-206 Nm).
4.
Install torque rod (9), two washers (10), two screws (11), two washers (14), and two new locknuts (13). Hand-tighten
locknuts.
9
10,11
12
13,14
0255 00-4
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |