Control Valve Module Assembly - Continued

TM 9-2320-303-24-2

TRANSMISSION OVERHAUL - CONTINUED

0248 00

MODULE OVERHAUL - CONTINUED

Control Valve Module Assembly - Continued

NOTE

Stationary clutch solenoid body assembly procedures are steps 19 through 22.

19.

Install valve (37), spring (36), and stop (35) in stationary clutch solenoid body (15). Install retention pin (32).

20.

Install three springs (30), solenoid regulator valves (31), six new O-rings (34), and three solenoids (33).

21.

As valve bores are filled, install three solenoid retention pins (29), smooth end first from bottom of solenoid body.

22.

Install two new seals (38) in stationary clutch solenoid body (15).

NOTE

Rotating clutch solenoid body assembly procedures are steps 23 through 27.

23.

Install spring (27), valve (26), and stop (28) in rotating clutch solenoid body (11) with retention pin (25).

24.

Install three springs (18), three solenoid regulator valves (19), new smaller O-rings (20), and new larger O-rings (21).

25.

Install face seal (17), two solenoids (22), and solenoid (23).

26.

Install solenoid retention pins (24), smooth end first, from bottom of rotating clutch solenoid body (11).

27.

Install pressure switch assembly (18) and two bolts (14). Tighten bolts to 44-71 lb-in (5-8 Nm).

NOTE

Control valve module assembly procedures are steps 28 through 37.

28.

Install main valve body assembly (87) and two bolts (40) (see page 0072 00-45 for illustration). Tighten bolts only fin-

ger tight.

29.

Install control harness assembly (9) with three bolts (10). Tighten bolts to 18-26 lb-in (2-3 Nm).

30.

Install new gasket (1), new face seal (4) and new filter (2) in suction filter housing (6).

31.

Install suction filter housing (6) with bolts (5) and two bolts (3). Tighten bolts only finger tight.

32.

Install solenoid separator plate (39).

33.

Install stationary clutch solenoid body assembly (15) with eight bolts (16). Tighten bolts only finger tight.

34.

Install rotating clutch solenoid body (11) with three bolts (12). Tighten bolts only finger tight.

35.

Install wiring harness cover plate (8) with four bolts (7). Tighten bolts only finger tight.

36.

Connect all electrical connectors. Remove tags.

37.

Evenly tighten cover plate bolts (7), suction filter bolts (3 and 5), valve body bolts (10, 12, and 16). Tighten all bolts to

7-10 lb-ft (10-13 Nm).

0248 00-46