Control Valve Module Disassembly - Continued

TM 9-2320-303-24-2

TRANSMISSION OVERHAUL - CONTINUED

0248 00

MODULE OVERHAUL - CONTINUED

Control Valve Module Disassembly - Continued

20.

Remove solenoid separator plate (39).

NOTE

Main valve body disassembly procedures are steps 21 through 34.

21.

If damaged, remove retention pin (74) from main valve body (87).

NOTE

Solenoid retention pins must be removed from bottom of valve body. Note grooved end of pin for positive

retention.

22.

Remove solenoid retention pin (49) from bottom of valve body (87).

23.

Remove solenoid (71), small O-ring (72), and large O-ring (73).

24.

Check resistances of solenoids. Resistance must be 2-5 ohms.

25.

Remove valve retention pin (43). Remove stop (52), spring (51), and converter flow valve (50).

26.

Remove valve retention pin (46), stop (53), spring (54), and lubrication regulator valve (55).

WARNING

Spring (57) is highly compressed. Be extremely careful during disassembly. Personal injury can occur if

spring force is not controlled.

27.

Install spring compressor tool (J35924). Compress spring (57), then remove valve retention pin (47). Carefully release

spring force by rotating tool handle counterclockwise. Remove spring compressor tool.

J35924

28.

Remove stop (56), spring (57), and main regulator valve (58).

29.

Push against stop (59) to compress spring (60) and remove valve retention pin (48). Slowly release pressure against stop

and remove stop, spring, and main control valve (61).

30.

Remove valve retention pin (45), stop (77), spring (76), and C2 latch valve (75).

31.

Remove retention pin (41), stop (84), spring (85), and exhaust back pressure valve (86).

0248 00-42