 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-2
STARTER REPAIR - CONTINUED
0235 00
DISASSEMBLY - CONTINUED
19.
Remove nut (59), washer (60), insulator (61), and packing (62) from field ring (26). Discard packing.
CAUTION
When removing stud terminal, do not use hammer to tap stud out. To do so could cause damage to compo-
nents.
20.
To remove stud terminal (67), temporarily replace nut (59) flush with end of stud. Using suitable pliers, work stud out
while supporting field coil (65).
21.
Remove insulator (68) and bushing (63) from field ring (26).
22.
Remove eight screws (66), four pole pieces (64), field coil (65), and insulator (69) from field ring (26).
59
60
61
69
62
63
26
64
68
67
65
66
64
ASSEMBLY
1.
Install insulator (69) in field ring (26).
2.
Install field coil (65) in field ring (26) so that terminal stud holes in field coil and field ring line up.
CAUTION
Pole pieces must be installed so that slot clears field coil contact tab. Failure to do so will cause damage to
starter motor.
3.
Install four pole pieces (64) and eight screws (66).
CAUTION
Insulator must be installed between field coil and field ring. Failure to do so will cause a short, damaging
starter motor.
4.
Install insulator (68) and stud terminal (67) through field coil (65) and field ring (26).
5.
Install bushing (63), new packing (62), insulator (61), washer (60), and nut (59) on stud terminal (67).
0235 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals