 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
SEAT REPAIR - CONTINUED
0185 00
ASSEMBLY
1.
Install two rubber bumpers (73) to riser (71).
2.
Install two bearings (62) into lever (81) with flanges of bearings on outside of lever.
3.
Install lever (82) to lever (81) with two shoulder bolts (60) and nuts (66). Tighten nuts to 192-240 lb-in (22-27 Nm).
4.
Install two slide blocks (65) on rear of lever (82) and two bearing blocks (68) on front of lever (81).
5.
Install lever (81 and 82) assembly into riser (71) and install two screws (74) into bearing blocks (68).
6.
Install two spacers (63) and slide blocks (64) on ends of lever (81) and two bearing blocks (67) on ends of lever (82).
7.
Install upper plate (7) over bearing blocks (67) and slide blocks (64).
8.
Install two screws (61) to bearing blocks (67).
9.
Using blocking between upper plate (7) and riser (71) to hold upper plate in fully raised position.
10.
At rear of riser (71), install two stop blocks (70) with two screws (72).
11.
Press two bearings (79) into damper (80).
12.
Install damper (80) to riser (71) and lever (81) with two washers (78) and new push-on fasteners (77).
13.
Position air spring (69) with fitting facing forward.
14.
Install air spring (69) with washer (76), screw (75), and screw (59). Tighten screw (59) to 180-228 lb-in (20-26 Nm).
Tighten screw (75) to 108-132 lb-in (12-15 Nm).
15.
Connect air line (37) to air spring (69).
16.
Remove blocking supporting upper plate (7).
17.
Install knob (57) to tilt rod (58) and install two brackets (28) and tilt rod to isolator assembly (8).
18.
Install knob (52), new pop rivet (53), detent pin (49), and spring (46) to control handle (54).
19.
Install shoulder bolt (51), washer (50), split poly loom (49), spring (48), control handle (47), washer (46), and new lock-
nut (45) on channel (4).
20.
Connect spring (43) and split poly loom (41) to isolator assembly (8) and position channel to upper plate (7).
21.
Install screw (44) to latch bar (45) and install spacer (42), latch bar, and pivot block (35) to isolator assembly (8) with
washer (34) and bolt (39). Tighten bolt to 26-34 lb-ft (35-46 Nm).
22.
Connect end of spring (43) to latch bar (45).
23.
Install two rollers (51) to each of two guide assemblies (50).
24.
Position valve mount (40) and two guide assemblies (50) to isolator assembly (8).
25.
Install six new lockwashers (39) and screws (38) underneath isolator assembly (8) and six new lockwashers (39) and
screws (32) to sides of channel.
26.
Secure air lines (37) with three wire ties (36).
27.
Adjust isolator assembly (8) to forward position and install front isolator spring (32) and rubber bumper (31).
28.
Adjust isolator assembly (8) to rear position and install rear isolator spring (32) and rubber bumper (31).
0185 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals