 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
HOOD ADJUSTMENT - CONTINUED
0180 00
ADJUSTMENT- CONTINUED
16
6
NOTE
When performing step 24, amount of spacers must be equal under both hood mounting brackets. DO
NOT use more than 3/4 in (19 mm) of spacers.
24.
Using pry bar, raise front of hood (1) enough to insert or remove spacers (16) as needed to make gap between hood and
cowl (2) equal, as measured in step 22.
25.
Repeat step 22.
26.
Tighten two locknuts (6) to 85 lb-ft (115 Nm).
NOTE
When performing step 27, be extremely careful to prevent movement of locator brackets (14).
27.
Carefully tilt hood (1) to fully open position.
28.
Measure distance between centerline of bolt (9) and outboard face of hood guide (15). Distance must be 2-5/8 in (67
mm). If necessary, move hood guide to obtain correct measurement.
29.
Tighten four locknuts (5) to 178 lb-in (20 Nm).
30.
Tighten locknut (4) to 70 lb-ft (95 Nm).
14
4
15
2 5/8 IN (67 MM)
5
9
31.
Repeat steps 29 and 30 for opposite side.
END OF WORK PACKAGE
0180 00-5/(0180 00-6 blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals