 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
FRONT BUMPER REPLACEMENT - CONTINUED
0173 00
REMOVAL - CONTINUED
NOTE
Note bolt size and location to aid in installation.
4.
Remove 12 locknuts (12), washers (11), bolts (17), washers (18), two tow brackets (2), and front bumper (1) from vehi-
cle. Discard locknuts.
5.
Lower bumper (1) to ground and disconnect lifting device.
6.
Remove four spring pins (15), straight pins (16), and two bumper extensions (3) from front bumper (1).
7.
Remove two nuts (13) and four spring pin cables (14) from front bumper (1).
1
12
11
2
14
13
10
4
18
15
17
3
5
7
8
1
16
9
6
INSTALLATION
1.
Install four spring pin cables (14) to front bumper (1) with two nuts (13).
2.
Install two bumper extensions (3) on front bumper (1) with four straight pins (16), and spring pins (15).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
3.
Attach suitable lifting device to front bumper (1) using bumper extensions (3) as attaching points.
4.
Install front bumper (1) on vehicle with two tow brackets (2), 12 washers (18), bolts (17), washers (11), and new lock-
nuts (12). Tighten locknuts to 180-200 lb-ft (244-271 Nm).
5.
Install hook (9) on each tow bracket (2) with threaded bolt (8) and lock pin (10).
6.
Install bracket (5) on front bumper (1) with four washers (7), screws (6), and new locknuts (4).
0173 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals