 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
REAR SERVICE RELAY VALVE REPLACEMENT - CONTINUED
0145 00
REMOVAL
NOTE
Tag all tubes prior to disconnecting to aid in installation.
1.
Disconnect three tubes (4) and four hoses (1) from relay valve (2).
2.
Remove two locknuts (8), two washers (9), two screws (13), two washers (12), and relay valve (2). Discard locknuts.
3.
Remove four elbows (3) and connector (14).
4.
Remove two locknuts (11), two washers (10), two screws (5), two washers (6), and mounting bracket (7). Discard lock-
nuts.
4
5
3
6
2
7
1
8
9
1110
12
13
4
3
14
1
INSTALLATION
1.
Install mounting bracket (7), two washers (6), two screws (5), two washers (10), and two new locknuts (11).
WARNING
Make sure all air lines and fittings are clear of debris. Make sure excess pipe sealant compound does not
enter air lines or fittings. Failure to do so could result in equipment failure and/or injury to personnel.
Sealant compounds can burn easily, give off harmful vapors, and are harmful to skin and clothing. To
avoid injury or death, keep away from open fire and use in well-ventilated area. If sealant compound
gets on skin or clothing, wash immediately with soap and water.
2.
Coat pipe threads of four elbows (3) and connector (14) with pipe sealant compound.
3.
Install four elbows (3) and connector (14) on relay valve (2).
4.
Install relay valve (2), two washers (12), two screws (13), two washers (9), and two new locknuts (8).
5.
Connect three tubes (4) and four hoses (1) to relay valve (2).
END OF WORK PACKAGE
0145 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals