 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
FRONT BRAKE SPIDER AND BRAKE CHAMBER BRACKET REPLACEMENT - CONTINUED
0123 00
INSTALLATION
WARNING
Brakeshoe linings and inside drum friction surface must be free of all oil/grease and other contaminants
prior to assembly to ensure maximum braking capability. Oil/grease and other contaminants may compro-
mise braking that could lead to a serious accident resulting in injury and/or death.
1.
Install brake spider (3) on axle flange (13).
2.
Install seven capscrews (21), seven washers (12), and seven new locknuts (11) in brake spider (3). Tighten locknuts to
75 lb-ft (102 Nm) in sequence shown. Tighten locknuts again to 150-175 lb-ft (203-237 Nm) in sequence shown.
OPEN FOR
OPEN FOR
3
13
ABS SENSOR
ABS SENSOR
12
11
21
3.
Apply light coating of oil to two bushings (5) and two new seals (4).
4.
Install two bushings (5), with label ends facing each other, in brake chamber bracket (6) to depth of 0.375 in. (9.5 mm)
from each end of brake chamber bracket.
5.
Install two new seals (4) in brake chamber bracket (6) with lip of both seals facing toward vehicle.
6.
Install brake chamber bracket (6) on brake spider (3) as noted during removal, step 5.
7.
Install two capscrews (2), two washers (7), and two nuts (8).
8.
Apply light coating of GAA to two bushings (5) in brake chamber bracket (6).
9.
Install 2-piece dust shield (17) and two capscrews (16) on (18) on brake spider (3).
10.
Install two clamps (19), two capscrews (20), and two nuts (18) on brake spider (3).
11.
Install two washers (15) and two nuts (14) on brake spider (3).
12.
Install two capscrews (1), two washers (9), and two nuts (10).
0123 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals