 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
FRONT AXLE TOE-IN ALIGNMENT - CONTINUED
0118 00
ADJUSTMENT
NOTE
Perform steps 1 through 4 to adjust toe-in and perform steps 5 through 7 to adjust turn stop bolts.
1.
Loosen capscrews (4) at clamps (3) on each end of tie rod (2).
2.
Rotate tie rod (2) toward front of vehicle to increase toe-in; toward rear of vehicle to decrease toe-in.
3.
Tighten capscrews (4) to 40-55 lb-ft (54-75 Nm).
4.
Repeat alignment check steps 1 through 9.
NOTE
Steps 5 through 7 are the same for both sides.
5.
Measure length of stop bolt (6). Length must be 9/16 in. 1/16 in.
6.
If measurement from step 5 is not within tolerance, loosen locknut (5) and adjust stop bolt (6) to required length.
7.
Tighten locknut (5) to 28 lb-ft (38 Nm).
5
6
2
3
4
END OF WORK PACKAGE
0118 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals