 |
|||
|
|
|||
|
Page Title:
INTER-AXLE DRIVELINE U-JOINTS REMOVAL - CONTINUED |
|
||
| ||||||||||
|
|
 TM 9-2320-303-24-1
DRIVELINE U-JOINTS AND BEARINGS REPLACEMENT - CONTINUED
0117 00
INTER-AXLE DRIVELINE U-JOINTS REMOVAL - CONTINUED
3.
Remove two grease fittings (7) from universal joint (6).
NOTE
Note matchmarks on each half of inter-axle driveline for installation. Scribe or paint matchmarks on drive-
line if matchmarks are missing.
4.
Remove dust seal (9) and yoke (2) from inter-axle driveline (3).
5.
Remove grease fitting (8) from yoke (2).
NOTE
Perform the following steps at rear end of inter-axle driveline.
6.
Remove two screws (13) from each of two bearing caps (14).
7.
Remove two bearing caps (14) and universal joint (12) from inter-axle driveline (3).
8.
Remove two grease fittings (11) from universal joint (12).
MAIN DRIVELINE U-JOINTS INSTALLATION
NOTE
Perform the following steps at rear end of main driveline.
1.
Install two grease fittings (11) on universal joint (12).
2.
Position universal joint (12) and two bearing caps (14) to main driveline (3).
3.
Install two new screws (13) on each of two bearing caps (14). Tighten screws to 36 lb-ft (49 Nm).
4.
Install two bearings (10) on universal joint (12).
5.
Lubricate universal joint (14) (WP 0024 00).
NOTE
Perform the following steps at front end of main driveline.
6.
Install grease fitting (8) on yoke (2).
NOTE
Align matchmarks on each half of main driveline.
7.
Install dust seal (9) and yoke (2) on main driveline (3). Tighten dust seal.
8.
Install two grease fittings (7) on universal joint (6).
9.
Position universal joint (6) and two bearing caps (5) on main driveline (3).
10.
Install two screws (4) on each of two bearing caps (5). Tighten screws to 36 lb-ft (49 Nm).
11.
Install two bearings (1) on universal joint (6).
12.
Lubricate yoke (2) and universal joint (6) (WP 0024 00).
13.
Install main driveline (WP 0116 00).
0117 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals