Figure 5. Pulling Terminal to Seat. - TM-9-2320-303-24-10624

TM 9-2320-303-24-1

ELECTRICAL CONNECTORS MAINTENANCE - CONTINUED

0098 00

(8)

Release crimping tool with lock lever located between handles, in case of jamming.

NOTE

For ECM 30-pin connectors, put locking tang opposite lettered side.

(9)

Align locking tang of terminal with lettered side of connector.

(10)

Pull cable back through connector until a click is heard (Figure 5). Position seal into connector.

PULL CABLE UNTIL

TERMINAL CLICKS

INTO PLACE

Figure 5. Pulling Terminal to Seat.

Removal and Repair. A tang on terminal locks into a tab molded into plastic connector to retain cable assembly.

Remove Metri-Pack 150 terminals using the following instructions:

(1)

Insert removal tool into cavity of connector, placing tip of tool between locking tang of terminal and wall

of cavity (Figure 6).

0098 00-10