 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
UPPER RIGHT DASH PANEL REPLACEMENT - CONTINUED
0065 00
REMOVAL - CONTINUED
12.
Remove two screws (15), guard (14), and control valve (18) from panel (7).
13.
Remove two elbows (20), sending unit (22), and tee (19) from control valve (18).
14.
Remove connector (28) from driver display unit (29).
15.
Remove two screws (13), two nuts (27), and driver display unit (29) from panel (7).
16.
Remove two air vents (9) from panel (7).
17.
Remove panel (7) from dashboard.
INSTALLATION
1.
Install two air vents (9) on panel (7).
2.
Position panel (7) to dashboard.
3.
Install driver display unit (29) to panel (7) with two screws (13) and two nuts (27).
4.
Install connector (28) to driver display unit (29).
WARNING
Adhesives and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in a well-ventilated area. If adhesive or
sealing compound contacts skin or clothing, wash immediately with soap and water.
NOTE
Two control valves are installed the same way. One control valve is illustrated. Perform steps 5 and 6 for
all control valves.
Apply pipe sealing compound to threads of all fittings before installation.
5.
Install tee (19), two elbows (20), and sending unit (22) on control valve (18).
6.
Install control valve (18) and guard (14) on panel (7) with two screws (15).
7.
Install two tubes (21). Install connector (23) on sending unit (22).
8.
Install three label holders (17) on panel (7).
9.
Install two switches (25) on panel (7) with two nuts (16).
10.
Install three fiber optic labels (24) on panel (7).
11.
Install two connectors (26) on switches (25).
12.
If removed, install three washers (6), knobs (5), and screws (4) on light switch (3).
13.
Install light switch (3) on panel (7) with four screws (10) and nuts (2).
14.
Install connector (1) on light switch (3).
15.
Install cap assembly (11) on panel (16).
16.
Install 12V power receptacle (12) in cap assembly (11).
17.
Connect connector (30) to 12V power receptacle (12).
18.
Position panel (7) on dash and install five screws (8).
0065 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals