 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
EXHAUST PIPE AND CLAMP REPLACEMENT - CONTINUED
0043 00
REMOVAL
1.
Loosen clamp (6) and seal clamp (8) and remove exhaust outlet pipe (5).
2.
Remove clamp (6) and seal clamp (8). Discard seal clamp.
3.
Remove seal clamp (10) and flex pipe (9). Discard seal clamp.
NOTE
Note location of heat shield for installation.
4.
Remove clamp (21) and heat shield (17).
5.
Loosen seal clamp (24) and remove four nuts (13), two saddle clamps (7), and pipe (11).
6.
Remove and discard seal clamp (24).
7.
Remove two nuts (14), two washers (15), two screws (22), two washers (23), and two brackets (12) from frame rail (16).
8.
Remove seal clamp (18), flex pipe (20), seal clamp (26), and pipe elbow (19). Discard seal clamps.
9.
Remove two nuts (1), washers (27), saddle clamp (4), seal clamp (3), and muffler inlet pipe (25) from muffler (2). Dis-
card seal clamp.
INSTALLATION
WARNING
Install seal clamps only hand-tight until all exhaust pipes are installed and tightened down. Failure to do so
will cause exhaust leaks and can result in serious personnel injury.
1.
Install new seal clamp (3) and muffler inlet pipe (25) on muffler (2).
NOTE
Install quantity of washers noted during removal step 8.
2.
Install saddle clamp (4), washers(s) (27), and two nuts (1).
3.
Install two brackets (12), two washers (23), two screws (22), two washers (15), and two nuts (14) on frame rail (16).
4.
Install two saddle clamps (7), pipe (11), and four nuts (13) loosely on two brackets (12).
5.
Install new seal clamp (24), flex pipe (20), new seal clamp (18), pipe elbow (19), and new seal clamp (26).
6.
Install heat shield (17) and clamp (21).
7.
Install new seal clamp (10), flex pipe (9), new seal clamp (8), exhaust outlet pipe (5), and clamp (6).
8.
Tighten four nuts (13).
9.
Tighten all seal clamps (3, 8, 10, 17, 18, and 24) in three increments to 33 lb-ft (45 Nm).
0043 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals