 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
MUFFLER AND EXHAUST STACK REPLACEMENT - CONTINUED
0042 00
INSTALLATION
NOTE
Perform steps 1 through 4 only if brackets or backing plate were removed.
1.
Install new support bracket (32), 11 new capscrews (33), 11 new washers (34), and 11 new locknuts (35).
2.
Install new upper support bracket (18), six new capscrews (17), six new washers (36), six new locknuts (37), two screws
(21), two washers (16), and two nuts (15).
3.
Install backing plate (30), new lower support bracket (29), new bracket (31), 10 capscrews (38), 10 washers (39), and 10
locknuts (40).
4.
Install right side cab liner (WP 0176 00).
5.
Install two isolators (23), two washers (22), two brackets (19), two screws (20), two washers (25), and two nuts (28) in
upper support bracket (18).
6.
Repeat step 5 for installation of two brackets (24 and 26) in lower support bracket (13).
7.
Install two heat shield clamps (7), two screws (6), and two nuts (5) on muffler (12).
8.
Slide heat shield (8) on muffler (12) and install eight screws (9).
WARNING
Install seal clamps only hand-tight until all exhaust pipes are installed and tightened down. Failure to do so
will cause exhaust leaks and can result in serious personnel injury.
9.
Install new seal clamp (11) on muffler (12).
33
33
20
32
34
19
35
15
16
37
21
36
22
18
33,34,35
35 34
27
25
17
23
28
24
20
31
30
40
39
40
26
39
40
22
29
38
23
38
25
28
402-195
0042 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals