 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
MUFFLER AND EXHAUST STACK REPLACEMENT - CONTINUED
0042 00
REMOVAL
1.
Remove four nuts (1), two saddle clamps (3), and exhaust stack (4).
2.
Using suitable lifting device, support muffler (12) and loosen seal clamp (11).
NOTE
Quantity of washers may vary. Washers are used for alignment.
3.
Remove two nuts (13), saddle clamp (10), washers (2), muffler (12), and seal clamp (11). Discard seal clamp.
4.
Remove eight screws (9) and slide heat shield (8) off muffler (12).
5.
Remove two nuts (5), two screws (6), and two heat shield clamps (7).
1
2
3
4
6
7
8
5
1
3
9
12
6
13
7
2
10
5
11
9
10
6.
Remove two nuts (28), two washers (25), two screws (20), two brackets (24 and 26), two washers (22), and two isolators
(23) from lower support bracket (29).
7.
Repeat step 6 for removal of two brackets (19) from upper support bracket (18).
NOTE
Perform steps 8 through 10 only if brackets or backing plate have been damaged.
8.
Remove right side cab liner (WP 0176 00).
9.
Remove 10 lock bolts and collars (27), bracket (31), lower support bracket (29), and backing plate (30).
0042 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals