 |
|||
|
|
|||
|
Page Title:
REMOVAL OF CROSSOVER TUBE (FOR CENTER COVER ONLY) |
|
||
| ||||||||||
|
|
 TM 9-2320-303-24-1
ROCKER ARM HOUSING COVERS MAINTENANCE - CONTINUED
0026 00
REMOVAL OF CROSSOVER TUBE (FOR CENTER COVER ONLY)
1.
Unscrew and remove ether atomizer line (3).
2.
Unscrew and remove four capscrews (4), washers (5) and gasket (6). Discard gasket.
3.
Loosen upper clamp (7). If rubber connector is damaged, replace.
4.
Remove crossover tube (8).
REMOVAL OF COVER
1.
Unscrew and remove five capscrews (9) and washers (10).
2.
Lift off rocker arm housing cover (11).
3.
Take off gasket (1) and discard.
CLEANING
1.
Clean rocker arm housing cover (11) with detergent.
2.
Rinse with clean water.
3.
Wipe grease from rim of engine retarder housing (2) where gasket rests.
INSTALLATION OF COVER
1.
Set new gasket (1) into place on engine retarder housing (2).
2.
Set rocker arm housing cover (11) onto gasket (1).
3.
Tighten capscrews (9) and washers (10) to 15 lb-ft (20 Nm).
INSTALLATION OF CROSSOVER TUBE (CENTER COVER ONLY)
1.
Hold crossover tube (8) and new crossover tube gasket (6) in place and attach with capscrews (4) and washers (5).
2.
Tighten upper clamp (7).
3.
Tighten crossover tube capscrews (4).
4.
Connect and tighten ether atomizer line (3).
0026 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals