 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-302-20-2
REAR VIEW MIRROR REPLACEMENT (M915A3 NEW MODEL, M916A3, M917A2) - CONTINUED
0276 00
REMOVAL - CONTINUED
20
21
6
22
23
24
25
6
26
INSTALLATION
NOTE
Perform steps 1 and 2 to install mirror support to mounting brackets on cab door.
If vehicle is equipped with bracket-mounted spotter mirror, perform steps 4 and 5.
1.
Position mirror support (6) on bracket (20), install screw (21), spring (22), and cap nut (23).
2.
Secure support (6) to bracket (25) with screw (24) and cap nut (26).
NOTE
Ensure that mounting surface for spotter mirror is clean and dry.
3.
If spotter mirror was replaced, remove paper backing from new spotter mirror (7). Press spotter mirror in place, centered
at bottom of mirror (1).
4.
Install spotter mirror (15) on bracket (17) with nut (16).
5.
Install bracket (17) with washer (19) and nut (18).
NOTE
Perform steps 4 and 5 at top and bottom of mirror.
6.
Install angle bracket (8) to mirror (1) with two washers (11), new lockwasher (10), and nut (9).
7.
Install mirror (1) to support (6) with screw (14), four washers (13), and new locknut (12) through angle bracket (8).
8.
Connect four remote-control mirror connectors (5) to connectors of wiring harness (3).
9.
Feed connectors (5) and excess wiring inside housing of mirror (1) and install grommet (4).
10.
Secure wiring harness (3) on support (6) with new tiedown straps (2).
0276 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals