ADJUSTMENT - CONTINUED - TM-9-2320-302-20-20907

TM 9-2320-302-20-2

CAB DOOR ADJUSTMENT - CONTINUED

0267 00

ADJUSTMENT - CONTINUED

Repeat steps 4 and 5 until cab door (9) is properly adjusted.

NOTE

Cab door is fully closed when you hear two clicks of door latch. Door should not have to be slammed shut.

If it is necessary to slam cab door shut, door must be adjusted.

With cab door (9) fully closed, check in-out position of top of cab door and flange (10) at hinge (11). Cab door must be

flush +/- 1/16 in (1.58 mm).

NOTE

Perform steps 8 and 9 only if top of cab door in-out position requires adjustment.

To adjust top of cab door (9), loosen adjusting screw (2) and move cab door in or out to required measurement. Tighten

adjusting screw.

Repeat steps 7 and 8 until top of cab door (9) is properly adjusted.

10.

With cab door (9) fully closed, check in-out position of bottom of cab door and flange (10) at hinge (11). Cab door must

be flush +/- 1/16 in (1.58 mm)

NOTE

Perform steps 11 and 12 only if bottom of cab door in-out position requires adjustment.

11.

To adjust bottom of cab door (9), loosen adjusting screw (3) and move cab door in or out to required measurement.

Tighten adjusting screw.

12.

Repeat steps 10 and 11 until bottom of cab door (9) is properly adjusted.

0267 00-3