 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-302-20-2
SEAT REPAIR - CONTINUED
0250 00
ASSEMBLY - CONTINUED
17.
Install knob (57) to tilt rod (58) and install two brackets (28) and tilt rod to channel (8).
18.
Install knob (52), new pop rivet (53), detent pin (49), and spring (46) to control handle (54).
19.
Install shoulder bolt (51), washer (50), split poly loom (49), spring (48), control handle (47), washer (46), and new lock-
nut (45) on channel (4).
20.
Connect spring (43) and split poly loom (41) to channel (8) and position channel to upper plate (7).
21.
Install screw (44) to latch bar (45) and install spacer (42), latch bar, and pivot block (35) to channel (8) with washer (34)
and bolt (39). Tighten bolt to 26-34 lb-ft (35-46 Nm).
22.
Connect end of spring (43) to latch bar (45).
23.
Install two rollers (51) to each of two guide assemblies (50).
24.
Position valve mount (40) and two guide assemblies (50) to channel (8).
25.
Install six new lockwashers (39) and screws (38) underneath channel (8) and six new lockwashers (39) and screws (32)
to sides of channel.
26.
Secure air lines (37) with three wire ties (36).
27.
Adjust channel (8) assembly to forward position and install front isolator spring (32) and rubber bumper (31).
28.
Adjust channel (8) assembly to rear position and install rear isolator spring (32) and rubber bumper (31).
NOTE
Perform steps 28 through 33 to assemble seat frame.
31
33
34
28
30
32
32
31
29
35
8
56
36
58
37
55
38
53 54
57
39
48
42
52
51
47
40
49
41
50
44
46
43
39
45
38
7
0250 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals