 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-302-20-2
SEAT REPAIR - CONTINUED
0250 00
DISASSEMBLY - CONTINUED
4.
Remove two wires (11) and remove back cover (10) and pad (9) from frame (12).
5.
Remove seat pad support (20) and two seat tilt blocks (19).
6.
Remove two pushnuts (13) and remove linkage (14) from slide shaft (21) and adjustment block (16). Discard pushnuts.
7.
Remove roll pin (27), adjustment shaft (26), spacer (17), and adjustment block (16) from frame (12). Remove knob (25)
from adjustment shaft. Discard roll pin.
8.
Remove two pushnuts (15), support shaft (22), two springs (23), and slide shaft (21). Discard pushnuts.
9.
Remove screw (24) and stop block (18).
10
9
11
25
12
15
26
24
27
23
13
22
14
21
15
20
16
17
18
19
10.
With channel (8) assembly still in rear position, remove isolator spring (32) and rubber bumper (31) at rear.
11.
Adjust channel (8) assembly to forward position and remove isolator spring (32) and rubber bumper (31) at front.
12.
Remove three wire ties (36) from air lines (37).
13.
Remove six screws (38) and lockwashers (39) from sides of channel (8) and six screws (38) and lockwashers (39) from
underneath channel to free two guide assemblies (50). Discard lockwashers.
14.
Remove two guide assemblies (50) and valve mount (40) from channel (8).
15.
Remove two rollers (51) from each guide assembly (50).
16.
Disconnect end of spring (43) from latch bar (45).
17.
Remove bolt (33), washer (34), pivot block (35), latch bar (45), and spacer (42) from channel (8). Remove screw (44)
from latch bar.
0250 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals