 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-302-20-2
HOOD PROP AND MOUNT REPLACEMENT (M915A3 NEW MODEL,
M916A3, M917A2) - CONTINUED
0248 00
HOOD PROP REMOVAL - CONTINUED
3.
If stowed, remove hood prop (1) from bracket (3).
4.
Remove two screws (6) and hood prop (1) with bracket (4) from hood (8).
NOTE
Note position of jamnut to ensure proper adjustment of hood prop length on installation.
5.
As required, loosen jamnut (5) and separate hood prop (1) from clevis (7).
4
5
1
3
8
6
7
HOOD PROP INSTALLATION
1.
If separated, install hood prop (1) on clevis (7). Tighten jamnut (5) so that jamnut is in same position as noted before it
was removed.
2.
Install mounting bracket (4) with hood prop (1) to hood (8) with two screws (6).
NOTE
Adjust hood prop length as required at jamnut.
3.
Check that length of hood prop (1) is correct: Extend prop open and hook end through slot in bracket (2) at top of radia-
tor. Weight of hood should rest on prop when hood is fully open and tilt assist cables are tight.
4.
Remove support from hood.
HOOD MOUNT REMOVAL
NOTE
Note quantity of spacers for installation, to assist in hood adjustment.
1.
Remove locknut (12), screw (10), hood mount locator (9), and spacers (13) from hood wedge (11). Discard locknut.
0248 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals