 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-302-20-2
REAR AIR BRAKE CHAMBER REPLACEMENT - CONTINUED
0182 00
REMOVAL
NOTE
Tag air hoses to aid in installation.
Each of four rear brake chambers are replaced the same way. One is shown.
1.
Disconnect service brake hose (5) and spring brake hose (6) from service brake fitting (4) and spring brake fitting (7).
2.
Remove two cotter pins (11) and clevis pins (3) from brake chamber clevis (10). Discard cotter pins.
3.
Remove two locknuts (1) and washers (2). Discard locknuts.
4.
Remove brake chamber (9).
5.
Remove service brake fitting (4) from brake chamber (9).
6.
Remove spring brake fitting (7) from brake chamber (9).
5
6
4
3
1
7
2
8
9
12
11
10
INSTALLATION
WARNING
Adhesives and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin
and clothing. To avoid injury or death, keep away from open fire and use in a well-ventilated area. If
adhesives or sealing compound contacts skin or clothing, wash immediately with soap and water.
Ensure all air lines and fittings are clear of debris and excess pipe sealing compound does not enter air
lines or fittings. Failure to follow this warning could result in injury to personnel or damage to equip-
ment.
1.
Lightly coat threads of service brake fitting (4) with pipe sealing compound. Install fitting on brake chamber (9).
2.
Lightly coat spring brake fitting (7) with pipe sealing compound. Install fitting on brake chamber (9).
NOTE
Brake chamber is mounted in upper part of figure 8 hole.
3.
Install brake chamber (9) so that service brake fitting (4) and spring brake fitting (7) are accessible.
0182 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals