 |
|||
|
|
|||
|
Page Title:
REAR SLACK ADJUSTER INSTALLATION - CONTINUED |
|
||
| ||||||||||
|
|
 TM 9-2320-302-20-2
SLACK ADJUSTER AND S-CAM REPLACEMENT- CONTINUED
0180 00
REAR SLACK ADJUSTER INSTALLATION - CONTINUED
5.
Remove screw (30), spring (32), and pawl (33) from slack adjuster (23).
6.
Hold s-cam (18) in position and rotate adjusting screw (31) to align slack adjuster (23) with rear brake chamber clevis
(13).
7.
Install two clevis pins (16 and 17) on rear brake chamber clevis (13).
8.
Install pawl (33), spring (32), and screw (30) on slack adjuster (22). Tighten screw to 15-30 lb-ft (20-27 Nm).
31
18
23
30,32,33
17
13
16
9.
Ensure that s-cam (18) is against brake spider (34).
10.
Attach magnetic base of dial indicator to brake spider (34) with indicator point on end surface of s-cam (18). Set dial
indicator to zero.
11.
Push s-cam (18) outward to end of travel and check new reading on dial indicator. If reading is more than 0.06 in (1.5
mm), perform Removal steps 2 through 4 and Installation steps 1 through 11.
18
34
12.
Install new cotter pins (14 and 15) on clevis pins (16 and 17).
0180 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals