 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-302-20-2
FRONT AXLE TOE-IN ALIGNMENT - CONTINUED
0168 00
ALIGNMENT CHECK - CONTINUED
9.
Measurement at front of tires must be 1/16 inch or less than rear measurement for proper toe-in alignment. If measure-
ment is not as specified, perform alignment procedure.
ADJUSTMENT
NOTE
Perform steps 1 through 4 to adjust toe-in alignment.
1.
Loosen screws (4) at clamps (3) on each end of tie rod (2).
2.
Rotate tie rod (2) toward front of vehicle to increase toe-in or rotate tie rod toward rear of vehicle to decrease toe-in.
3.
Tighten screws (4) to 40-55 lb-ft (54-75 Nm).
6
2
5
3
9/16 in +/- 1/16 in
4
4.
Repeat alignment check procedure.
NOTE
Perform steps 5 through 7 to adjust turn stop bolts.
Steps 5 through 7 are the same for both sides.
5.
Measure length of stop bolt (6). Length must be 9/16 in +/- 1/16 in (14 mm +/- 1.6 mm).
6.
If measurement from step 5 is not within tolerance, loosen locknut (5) and adjust stop bolt (6) to required length.
7.
Tighten locknut (5) to 28 lb-ft (38 Nm).
END OF WORK PACKAGE
0168 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals