 |
|||
|
|
|||
|
Page Title:
INTER-AXLE DRIVELINE U-JOINTS INSTALLATION |
|
||
| ||||||||||
|
|
 TM 9-2320-302-20-2
DRIVELINE U-JOINTS AND BEARINGS REPLACEMENT (M915A3 OLD MODEL) - CONTINUED
0167 00
INTER-AXLE DRIVELINE U-JOINTS INSTALLATION
NOTE
Perform the following steps at rear end of inter-axle driveline.
1.
Install two grease fittings (12) on universal joint (14).
2.
Position universal joint (14) and two bearing caps (16) on inter-axle driveline (4).
3.
Install two new screws (15) on each of two bearings caps (16). Tighten screws to 36 lb-ft (49 Nm).
Lubricate universal joint (14) (WP 0023 00).
4.
5.
Install grease fitting (9) on yoke (3).
NOTE
Align matchmarks on each half of inter-axle driveline.
6.
Install dust seal (10) and yoke (3) on inter-axle driveline (4). Tighten dust seal.
NOTE
Perform the following steps at front end of inter-axle driveline.
7.
Install two grease fittings (8) to universal joint (7).
8.
Position universal joint (7) and two bearing caps (6) on yoke (3) of inter-axle driveline (4).
9.
Install two new screws (5) on each of two bearing caps (6). Tighten screws to 36 lb-ft (19 Nm).
Lubricate yoke (3) and universal joint (7) (WP 0023 00).
10.
Install inter-axle driveline (WP 0165 00).
11.
11
12
13
14
4
11
10
3
9
2
15
16
1
8
5
6
7
2
END OF WORK PACKAGE
0167 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals