 |
|||
|
|
|||
|
Page Title:
MAIN DRIVELINE U-JOINTS REMOVAL - CONTINUED |
|
||
| ||||||||||
|
|
 TM 9-2320-302-20-2
DRIVELINE U-JOINTS AND BEARINGS REPLACEMENT (M915A3 OLD MODEL) - CONTINUED
0167 00
MAIN DRIVELINE U-JOINTS REMOVAL - CONTINUED
NOTE
Note matchmarks on each half of main driveline for installation. Scribe or paint matchmarks on driveline if
matchmarks are missing.
6.
Remove dust seal (10) and yoke (3) from main driveline (4).
7.
Remove grease fitting (9) from yoke (3).
NOTE
Perform following steps at rear end of main driveline.
8.
Remove retaining wire (13) from groove of two bearings (11).
9.
Remove two bearings (11) from universal joint (14).
10.
Remove two screws (15) from each of two bearing caps (16). Discard screws.
11.
Remove two bearing caps (16) and universal joint (14) from main driveline (4).
12.
Remove two grease fittings (12) from universal joint (14).
11
12
13
14
4
11
10
3
9
2
15
16
1
8
5
6
7
2
INTER-AXLE DRIVELINE U-JOINTS REMOVAL
NOTE
Perform the following steps at front end of inter-axle driveline.
1.
Remove two screws (5) from each of two bearing caps (6). Discard screws.
2.
Remove two bearing caps (6) and universal joint (7) from yoke (3) of inter-axle driveline (4).
0167 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals