 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-302-20-2
ANTI-LOCK BRAKE SYSTEM (ABS) ELECTRONIC CONTROL UNIT (ECU) AND ECU
WIRING HARNESS REPLACEMENT (M915A3 NEW MODEL, M916A3, M917A2) - CONTINUED
0127 00
REMOVAL - CONTINUED
11.
Inside cab, move rubber floor mat (28) aside to expose base of connector (26).
12.
Drill through center of two rivets (27) and remove connector (26) with ECU wiring harness (8) from cab floor (23). Dis-
card rivets.
8
26
23
28
27
INSTALLATION
NOTE
To install ABS ECU only, perform steps 10 through 12.
Ensure that conduit is installed around ABS ECU wiring harness.
Install new tiedown straps and electrical tape as necessary.
1.
Inside cab, install ECU wiring harness (8) with connector (26) to cab floor (23) with two new rivets (27).
2.
Move rubber floor mat (28) back to original position.
3.
Underneath right rear of cab, install connector (24) to underside of cab floor (23) and tighten screw (25).
0127 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals